182
Configuring the DHCPv6 client
This feature is available in Release 2406P03 and later versions.
Overview
With DHCPv6 client configured, an interface can obtain configuration parameters from the DHCPv6
server.
A DHCPv6 client can use DHCPv6 to complete the following functions:
• Obtain an IPv6 address, an IPv6 prefix, and other configuration parameters.
• Support stateless DHCPv6. The DHCPv6 client can obtain configuration parameters except IPv6
address and IPv6 prefix. The interface obtains an IPv6 address through stateless IPv6 address
autoconfiguration. If the interface receives an RA message with the M flag set to 0 and the O flag
set to 1 during address acquisition, the interface performs stateless DHCPv6 to get other
configuration parameters.
DHCPv6 client configuration task list
Tasks at a
lance
(Required.) Perform one of the following tasks:
• Configuring IPv6 address acquisition
• Configuring IPv6 prefix acquisition
• Configuring stateless DHCPv6
(Optional.) Setting the DSCP value for DHCPv6 packets sent by the DHCPv6 client
(Optional.) Configuring the DHCPv6 client DUID
Configuring IPv6 address acquisition
Ste
Command
Remarks
1. Enter system view.
system-view N/A
To Next Page
Loading...
