HP 6125XLG - Specifying a Server for the DHCP Client; Configuring Option 184 Parameters for the Client

41
2. After getting the parameters, the DHCP client sends a TFTP request to obtain the configuration file
from the specified TFTP server for system initialization. If the client cannot get such parameters, it
performs system initialization without loading any configuration file.
To configure the IP address of the TFTP server and the boot file name in a DHCP address pool:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter DHCP address pool view.
dhcp server ip-pool pool-name N/A
3. Specify the IP address or the
name of a TFTP server.
• Specify the IP address of the TFTP
server:
tftp-server ip-address ip-address
• Specify the name of the TFTP server:
tftp-server domain-name
domain-name
By default, no TFTP server is
specified.
4. Specify the boot file name.
bootfile-name bootfile-name
By default, no boot file
name is specified.
Specifying a server for the DHCP client
Some DHCP clients need to obtain configuration information from a server, such as a TFTP server. You
can specify the IP address of that server. The DHCP server sends the server's IP address to DHCP clients
along with other configuration information.
To specify the IP address of a server:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter DHCP address pool
view.
dhcp server ip-pool pool-name N/A
3. Specify the IP address of a
server.
next-server ip-address By default, no server is specified.
Configuring Option 184 parameters for the client
To assign calling parameters to DHCP clients with voice service, you must configure Option 184 on the
DHCP server. For more information about Option 184, see "Option 184."
T
o configure option 184 parameters in a DHCP address pool:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter DHCP address pool view.
dhcp server ip-pool pool-name N/A