HP 6125XLG - Displaying and Maintaining ARP; Configuration Examples; Static ARP Configuration Example

8
Step Command Remarks
2. Enable ARP fast
update.
mac-address mac-move
fast-update
By default, ARP fast update is disabled for
MAC move.
Displaying and maintaining ARP
IMPORTANT:
Clearing ARP entries from the ARP table might cause communication failures. Make sure the entries to be
cleared do not affect current communications.
Execute display commands in any view and reset commands in user view.
Task Command
Display ARP entries.
display arp [ [ all | dynamic | multiport | static ] [ slot
slot-number ] | vlan vlan-id | interface interface-type
interface-number ] [ count | verbose ]
Display the ARP entry for a specified IP
address.
display arp ip-address [ slot slot-number ] [ verbose ]
Display the ARP entries for a specified VPN
instance.
display arp vpn-instance vpn-instance-name [ count ]
Display the aging timer of dynamic ARP
entries.
display arp timer aging
Clear ARP entries from the ARP table.
reset arp { all | dynamic | interface interface-type
interface-number | multiport | slot slot-number | static }
Configuration examples
Static ARP configuration example
Network requirements
As shown in Figure 4, hosts are connected to the switch, which is connected to the router through
interface Ten-GigabitEthernet 1/1/5 in VLAN 10.
To ensure secure communications between the router and switch, configure a static ARP entry for the
router on the switch.