183
Ste
Command
Remarks
2. Enter interface view.
• Layer 3 Ethernet interface:
interface interface-type
interface-number
• Layer 3 aggregate interface:
interface route-aggregation
interface-number
• Management Ethernet
interface:
interface m-ethernet
interface-number
• VLAN interface:
interface vlan-interface
interface-number
N/A
3. Configure the interface to use
DHCPv6 to obtain an IPv6
address and other
configuration parameters.
ipv6 address dhcp-alloc
[ rapid-commit ]
By default, the interface does not
use DHCPv6 for IPv6 address
acquisition.
Configuring IPv6 prefix acquisition
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
• Layer 3 Ethernet interface:
interface interface-type
interface-number
• Layer 3 aggregate interface:
interface route-aggregation
interface-number
• Management Ethernet
interface:
interface m-ethernet
interface-number
• VLAN interface:
interface vlan-interface
interface-number
N/A
3. Configure the interface to use
DHCPv6 to obtain an IPv6
prefix and other configuration
parameters.
ipv6 dhcp client pd prefix-number
[ rapid-commit ]
By default, the interface does not
use DHCPv6 for IPv6 prefix
acquisition.
Configuring stateless DHCPv6
Ste
Command
Remarks
1. Enter system view.
system-view N/A
To Next Page
Loading...
