HP 6125XLG - Page 197

186
Figure 75 Network diagram
Configuration procedure
You must configure the DHCPv6 server first before configuring the DHCPv6 client. For information about
configuring DHCPv6 server, see "Configuring the DHCPv6 server."
# C
onfigure VLAN-interface 2 to use DHCPv6 to obtain an IPv6 address and other configuration
parameters. Configure the interface to support DHCPv6 rapid address assignment.
<Switch> system-view
[Switch] interface vlan-interface 2
[Switch-Vlan-interface2] ipv6 address dhcp-alloc rapid-commit
[Switch-Vlan-interface2] quit
Verifying the configuration
# Display the DHCPv6 client information. The output shows that the client has obtained an IPv6 address
and other configuration parameters from the server.
[Switch] display ipv6 dhcp client
Vlan-interface2:
Type: Stateful client requesting address
State: OPEN
IAID: 0xf0019
Client DUID: 00030001000fe2ff0000
Preferred server:
Reachable via address: FE80::200:5EFF:FE0A:2303
Server DUID: 00030001000fe20a0a00
Address: 1:2::2
Preferred lifetime 60 sec, valid lifetime 60 sec
T1 30 sec, T2 48 sec
Will expire on Feb 4 2013 at 15:37:20 (50 seconds left)
DNS server addresses:
2000::FF
Domain name:
example.com
SIP server addresses:
2:2::4
SIP server domain names:
bbb.com