HP 6125XLG - Page 21

To Next Page

To Previous Page

Figure 5 Network diagram

Configuration procedure

# Create VLAN 10.

<Switch> system-view

[Switch] vlan 10

[Switch-vlan10] quit

# Add Ten-GigabitEthernet 1/1/5, Ten-GigabitEthernet 1/1/6, and Ten-GigabitEthernet 1/1/7 to

VLAN 10.

[Switch] interface Ten-GigabitEthernet 1/1/5

[Switch-Ten-GigabitEthernet1/1/5] port access vlan 10

[Switch-Ten-GigabitEthernet1/1/5] quit

[Switch] interface Ten-GigabitEthernet 1/1/6

[Switch-Ten-GigabitEthernet1/1/6] port access vlan 10

[Switch-Ten-GigabitEthernet1/1/6] quit

[Switch] interface Ten-GigabitEthernet 1/1/7

[Switch-Ten-GigabitEthernet1/1/7] port access vlan 10

[Switch-Ten-GigabitEthernet1/1/7] quit

# Create VLAN-interface 10 and specify its IP address.

[Switch] interface vlan-interface 10

[Switch-vlan-interface10] ip address 192.168.1.2 24

[Switch-vlan-interface10] quit

# Create service loopback group 1 and specify the multiport ARP service for the group.

[Switch] service-loopback group 1 type multiport

# Assign Ten-GigabitEthernet 1/1/4 to service loopback group 1.

[Switch] interface Ten-GigabitEthernet 1/1/4

[Switch-Ten-GigabitEthernet1/1/4] port service-loopback group 1

[Switch-Ten-GigabitEthernet1/1/4] quit

# Configure a multiport unicast MAC address entry that has MAC address 00e0-fc01-0000, and output

interfaces Ten-GigabitEthernet 1/1/5, Ten-GigabitEthernet 1/1/6, and Ten-GigabitEthernet 1/1/7 in

VLAN 10.

Swtich

XGE1/1/5 XGE1/1/7

XGE1/1/6

Server group

192.168.1.1/24

00e0-fc01-0000

Server ServerServer

Other manuals for HP 6125XLG