EasyManua.ls Logo

HP 6125XLG - Page 246

HP 6125XLG
284 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
235
Figure 96 Network diagram
Configuration procedure
Before the following configurations, configure an IP address for each interface, and make sure Switch A
and Switch B can reach each other.
1. Configure Switch A:
# Create service loopback group 1, and configure the service type as tunnel.
<SwitchA> system-view
[SwitchA] service-loopback group 1 type tunnel
# Add port Ten-GigabitEthernet1/1/5 to service loopback group 1.
[SwitchA] interface Ten-GigabitEthernet 1/1/5
[SwitchA-Ten-GigabitEthernet1/1/5] port service-loopback group 1
[SwitchA-Ten-GigabitEthernet1/1/5] quit
# Create a tunnel interface Tunnel 0, and specify the tunnel mode as GRE over IPv6.
[SwitchA] interface tunnel 0 mode gre ipv6
# Configure an IP address for the tunnel interface.
[SwitchA-Tunnel0] ip address 10.1.2.1 255.255.255.0
# Configure the source address of the tunnel interface as the IPv6 address of VLAN-interface 101
on Switch A.
[SwitchA-Tunnel0] source 2002::1:1
# Configure the destination address of the tunnel interface as the IPv6 address of VLAN-interface
101 on Switch B.
[SwitchA-Tunnel0] destination 2001::2:1
[SwitchA-Tunnel0] quit
# Configure a static route from Switch A through the tunnel interface to Group 2.
[SwitchA] ip route-static 10.1.3.0 255.255.255.0 tunnel 0
2. Configure Switch B:
# Create service loopback group 1, and configure the service type as tunnel.
<SwitchB> system-view
[SwitchB] service-loopback group 1 type tunnel
# Add port Ten-GigabitEthernet1/1/5 to service loopback group 1.
[SwitchB] interface Ten-GigabitEthernet 1/1/5
[SwitchB-Ten-GigabitEthernet1/1/5] port service-loopback group 1
[SwitchB-Ten-GigabitEthernet1/1/5] quit
# Create a tunnel interface Tunnel 0, and specify the tunnel mode as GRE over IPv6.
[SwitchB] interface tunnel 0 mode gre ipv6
XGE1/1/7
Vlan-int100
10.1.3.1/24
IPv4
Group 2
IPv4
Group 1
XGE1/1/7
Vlan-int100
10.1.1.1/24
Tunnel0
10.1.2.1/24
XGE1/1/6
Vlan-int101
2002::1:1/64
XGE1/1/6
Vlan-int101
2001::2:1/64
IPv6 network
GRE tunnel
Tunnel0
10.1.2.2/24
Switch A
Switch B
Service loopback port
XGE1/1/5XGE1/1/5

Table of Contents

Other manuals for HP 6125XLG

Related product manuals