To Next Page

To Previous Page

4 Removal and replacement

preliminary requirements

Tools required

You will need the following tools to complete the removal and replacement procedures:

●

Magnetic screw driver

●

Phillips P0 screw driver

●

Plastic case utility tool

●

Torx T5 screw driver

Service considerations

The following sections include some of the considerations that you must keep in mind during

disassembly and assembly procedures.

NOTE: As you remove each subassembly from the tablet, place the subassembly (and all

accompanying screws) away from the work area to prevent damage.

Plastic parts

CAUTION: Using excessive force during disassembly and reassembly can damage plastic parts.

Use care when handling the plastic parts. Apply pressure only at the points designated in the

maintenance instructions.

Cables and connectors

CAUTION: When servicing the tablet, be sure that cables are placed in their proper locations during

the reassembly process. Improper cable placement can damage the tablet.

Cables must be handled with extreme care to avoid damage. Apply only the tension required to unseat

or seat the cables during removal and insertion. Handle cables by the connector whenever possible. In

all cases, avoid bending, twisting, or tearing cables. Be sure that cables are routed in such a way that

they cannot be caught or snagged by parts being removed or replaced. Handle flex cables with

extreme care; these cables tear easily.

10 Chapter 4 Removal and replacement preliminary requirements

Questions and Answers:

Need help?

Do you have a question about the HP 7 Plus and is the answer not in the manual?

HP 7 Plus Specifications

General