To Next Page

To Previous Page

Remove the speaker:

1. Unsolder the speaker cables (1) from the system board terminals.

NOTE: When installing the speaker, the speaker red cable should be soldered to the system

board “+” terminal, and the speaker black cable should be soldered to the “-” terminal.

2. Release the speaker cable (2) from the retention clip built into the display panel assembly.

3. Detach the speaker (3) from the display panel assembly. (The speaker is attached to the

display panel assembly with double-sided adhesive.)

4. Remove the speaker.

Reverse this procedure to install the speaker.

Rear-facing webcam

Description Spare part number

2.0-MP rear-facing webcam (includes cable) 753193-001

Before removing the rear-facing webcam, follow these steps:

1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,

and then shut it down through the operating system.

2. Disconnect the power from the tablet by unplugging the power cord from the tablet.

3. Disconnect all external devices from the tablet.

Rear-facing webcam

Questions and Answers:

Need help?

Do you have a question about the HP 7 Plus and is the answer not in the manual?

HP 7 Plus Specifications

General