To Next Page

To Previous Page

CAUTION: Before positioning the tablet with the display panel facing down, make sure the work

surface is clear of tools, screws, and any other foreign objects. Failure to follow this caution can result

in damage to the display panel assembly.

1. Place the display panel assembly on a flat surface, display panel side down, with the power

button and volume buttons toward you.

2. Unsolder the battery cables from the terminals (1) on the system board.

NOTE: When installing the battery, the battery red/yellow cable should be soldered to the

system board “+” terminal, and the battery black cable should be soldered to the system board

“-” terminal.

3. Remove the battery (2).

Reverse this procedure to install the battery.

Antenna

Description Spare part number

Antenna Kit (includes wireless antenna transceiver and cable) 774998-001

Before removing the antenna, follow these steps:

1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,

and then shut it down through the operating system.

2. Disconnect the power from the tablet by unplugging the power cord from the tablet.

3. Disconnect all external devices from the tablet.

4. Remove the back cover (see

Back cover on page 14).

5. Disconnect the battery cables from the system board (see

Battery on page 16).

Antenna

Questions and Answers:

Need help?

Do you have a question about the HP 7 Plus and is the answer not in the manual?

HP 7 Plus Specifications

General