To Next Page

To Previous Page

Remove the system board:

1. Disconnect the following cables from the system board:

(1) Front-facing webcam cable (see

Front-facing webcam on page 21)

(2) Microphone cable (see

Microphone on page 20)

(3) Power/volume button board cable (see

Power/volume button board on page 22)

(4) Release the ZIF connector to which the display panel cable is attached, and then disconnect

the display panel cable from the system board

(5) Release the ZIF connector to which the TouchScreen cable is attached, and then disconnect the

TouchScreen cable from the system board

(6) Speaker cable (see

Speaker on page 18)

2. Remove the two Phillips PM1.4×2.75 screws (1) that secure the system board to the

display panel assembly.

3. Remove the system board (2).

24 Chapter 5 Removal and replacement procedures

Questions and Answers:

Need help?

Do you have a question about the HP 7 Plus and is the answer not in the manual?

HP 7 Plus Specifications

General