HP 70000 series - Page 324

Operating
Errors
2000
{
2999
Contact
the
nearest
HP
Sales and Service Oce for assistance.
2026
Check mixer bias
2027
Service mode -- do IP
Cause: This is a user-generated system protocol error. The bandwidth or reference select is not
in their AUTO modes.(For service use only.)
2028
Idler
is
unlocked
2029
Command
syntax error
Cause:
This
error
is generated when MSIB packet syntax is incorrect, or when a BDLP call is
does
not
have
the proper syntax.
Cure:
Please
document all the steps that led up to this error and contact your HP
representative.
2030
Scaling overflow
Cause: The user has requested a scale factor that is too large in the DWINDOW command.
Cure: Refer to the DWINDOW command description in the HP 70000 Modular Spectrum
Analyzer
Programming
Manual
for
limits
.
2031
Too
many
errors
Cause:
The
error
buer
has
been
lled.
2032
Hardware not present
Cause: A function was requested that required hardware not available in the system.
Cure: Use the DEBUG command to locate the programming error. Refer to the HP 70000
Modular Spectrum Analyzer Programming Manual .
Error Messages 6-17