EasyManuals Logo

HP 800 User Manual

HP 800
106 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
A-Class System Overview and Reference
A-Class Server System Regulatory Compliance Statements
Chapter 1
15
Declaration of Conformity
FCC STATEMENT (USA Only)
The United States Federal Communications Commission has specified that the following
notice be brought to the attention of users of this product:
NOTE This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Hewlett-Packard's system verification tests were conducted with HP-supported
peripheral devices and HP shielded cables, such as those you receive with your computer.
Changes or modifications not expressly approved by Hewlett-Packard could void the
user's authority to operate the equipment. Cables used with this device must be properly
shielded to comply with the requirements of the FCC.
FCC Regulations for Telephone Line Interconnection
This equipment complies with Part 68 of the FCC rules. On the outside surface of
this equipment is a label that contains, among other information, the FCC
registration, the FCC registration number and ringer equivalence number (REN). If
requested, this information must be provided to the telephone company.
This equipment uses the following Universal Service Code (USOC) jacks: RJ11C or
RJ11W (single line).
The REN is used to determine the quality of devices which may be connected to the
telephone line. Excessive RENs on the telephone line may result in the devices not
ringing in response to an incoming call. In most, but not all areas, the sum of the
RENs should not exceed five (5.0). To be certain of the number of devices that may be
connected to the line, as determined by total RENs, contact the telephone company
to determine the maximum REN for the calling area.
If this equipment causes harm to the telephone network, the telephone company
will, where practicable, notify you in advance that temporary discontinuance of
service may be required. If advance notice isn’t practical, the telephone company will
notify the customer as soon as possible. Also, you will be advised of your right to file
a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations, or
procedures that could affect the operation of the equipment. If this happens, the
telephone company will provide advance notice in order for you to make the
necessary modifications in order to maintain uninterrupted service.
If trouble is experienced with this equipment, please contact: Hewlett-Packard
Company, Response Center, 20 Perimeter Summit Boulevard, Atlanta, GA 30319
U.S.A. 1 (800) 633-3600 (Toll Free - North America Only) or 1 (404) 648-0000 (Main
Number)

Table of Contents

Other manuals for HP 800

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 800 and is the answer not in the manual?

HP 800 Specifications

General IconGeneral
BrandHP
Model800
CategoryServer
LanguageEnglish

Related product manuals