A-Class System Service
A-Class Server Cache Memory Removal and Replacement
Chapter 3
90
NOTE A-Class servers can only use Cache Memory SIMMs with part number A5182-60002.
Using Cache Memory SIMMs with any other part number may result in the server
failing it’s selftest.
Cache Memory board replacement procedures are described as follows:
Step 1. Open the ejector levers (down position).
Step 2. Note the two key notches on the Cache Memory board. One key notch is in the center
and one is toward the side. Orient the board so that the side key notch is toward the
server front, matching the keys in the connector.
Step 3. Align the board notches with the connector keys, fit the bottom sides of the board into
the ejector lever slots, and insert the board into the connector.
Step 4. Push the Cache memory board firmly and evenly into the connector until it clicks into
place. The ejector levers will automatically close.
Key notches
To Next Page
Loading...
Need help?
General