Speaker
The speaker is attached to the front of the chassis under the rotating drive cage.
1. Prepare the computer for disassembly (
Preparation for Disassembly on page 90).
2. Remove the access panel (
Computer Access Panel on page 99).
3. Remove the front bezel (
Front Bezel on page 100).
4. Rotate the drive cage to its upright position.
5. Disconnect the speaker wire from the white system board labeled SPKR
6. Remove the two screws that secure the speaker to the chassis.
Figure 7-58 Removing the speaker
7. Lift the speaker from the inside of the chassis to remove it.
To install the speaker, reverse the removal procedures.
136 Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
To Next Page
Loading...
