Power Switch Assembly
The power switch assembly is mounted to the front of the chassis and is removed by pulling it away
from the chassis.
1. Prepare the computer for disassembly (
Preparation for Disassembly on page 35).
2. Remove the computer access panel (
Computer Access Panel on page 43).
3. Remove the computer access panel (
Front Bezel on page 44).
4. Disconnect the cable from the black system board connector labeled PB/LED.
5. Press in on the tab (1) on the assembly.
6. Rotate the assembly downward (2), and then pull the assembly away from the chassis while
threading the wires through the hole in the front of the chassis.
Figure 6-48 Removing the power switch assembly
To install the power switch assembly, reverse the removal procedure.
74 Chapter 6 Removal and Replacement Procedures Convertible Minitower (CMT) Chassis
To Next Page
Loading...
