6. Connect the power cable (1) and data cable (2) to the rear of the drive.
Figure 6-33 Connecting the Drive Cables (Optical Drive shown)
7. If you are installing a new drive, connect the opposite end of the data cable to the appropriate
system board connector.
NOTE: If you are installing a SATA optical drive, connect the first optical drive to the white
SATA connector on the system board labeled SATA1. Connect a second optical drive to the next
available (unpopulated) SATA connector following the numbered sequence of the connectors.
If your are installing a media card reader, connect the USB cable to the USB system board
connector labeled MEDIA. If the media card reader includes a 1394 port, connect the 1394 cable
to the 1394 PCI card.
Refer to
System Board Drive Connections on page 57 for an illustration of the system board
drive connectors.
8. Replace the front bezel and computer access panel.
9. Reconnect the power cord and turn on the computer.
10. Lock any security devices that were disengaged when the computer access panel was removed.
11. Reconfigure the computer, if necessary.
64 Chapter 6 Removal and Replacement Procedures Convertible Minitower (CMT) Chassis
To Next Page
Loading...
