Procedure 14. W3 Line Switch Cable
17.
18.
Fold out the Al4 and Al5 assemblies as described in “Procedure 9. Al4 and Al5
Assemblies Removal,” steps 3 and 4.
Loosen the screw (1) securing W3, the line switch assembly, to the front frame. The screw
is captive. See Figure 4-25.
A6A
1
w9
i:
Figure 4-24. W3 Dress and Connection to A6 Power Supply
SI
11le
19. Remove
AlWl
and
AlWlDSl
f
rom the line-switch assembly. Let each hang freely.
Note
If contact removal tool, HP part number 8710-1791, is available, complete
assembly removal by performing “Removal,” steps 20 and 21. If not, skip to
“Removal,” step 22.
Assembly Replacement 4-49
To Next Page
Loading...
