Procedure 14. W3 Line Switch Cable
CONNECTOR
POSITION OF
TIE WRAP KNUCKLE
WIRE (98)
WIRE (928)
WIRE (8)
WIRE (918)
PLUNGER PUSHES CONTACT OUT
CONNECTOR BODY
CONTACT REMOVAL TOOL
‘--
WIRE
SK151
Figure 4-26. W3 Cable Connector
Replacement
(Using
Contact
Removal
Tool,
HP
part
number
87104791)
1. Ensure that the action of the switch is working properly. With a pair of wire cutters, clip
the tie wrap holding the cable to the contact housing of the replacement W3 assembly.
2. Using the contact removal tool, remove the four wires from the replacement cable
assembly connector.
4-52 Assembly Replacement
To Next Page
Loading...
