HP 8562E - Page 479

I
IF adjustment, automatic , 9-10
IF amplifier, 7-44
IF amplitude adjustments, 2-26
IF assembly, 7-49
IF assembly troubleshooting, 9-9, 9-21
IF bandpass adjustment, 2-21
IF filter, 4.8 kHz and 10.7 MHz problems, 9-18
IF filter troubleshooting, 10.7 MHz , 9-17
IF filter troubleshooting, 4.8 kHz, 9-17
IF filter troubleshooting, 4.8 kHz and 10.7 MHz,
9-18
IF gain uncertainty performance test failures,
9-12
IF/LOG check, 7-14
IF parameters adjusted, 9-10
IF section, 7-48
IF section general troubleshooting, 9-l
IF signature problems, 9-26
IF signature troubleshooting, 9-22
input attenuator, 7-44, 12-8
removal and replacement, 4-32
input switch problems, 9-19
instrument variations, l-2
intensity adjustments, 2-18
intensity problems, 10-10, 13-10
interface check, 7-14
interface section, 7-49
interface strobe troubleshooting, 8-30
internal assemblies, access to, 4-2
isolation amplifier problems, 9-20
J
jumper
write protect/enable, 7-6
K
keyboard
problems, 8-7, lo-16
kick start, 13-14
L
LC filter adjustments, 2-22
limiter problems, 9-20
linear amplifier troubleshooting, 9-14
linear fidelity adjustment, 2-32
line fuse blowing, 13-14
line generator, 10-4, 10-8
lines dim, lo-11
line switch cable
removal, 4-48
replacement, 4-52
List Equip softkey, 3-13
List Files softkey, 3-12
Load Conds softkey, 3-12
loading frequency response adjustment software,
3-5
local oscillator. See LO
LO control check, 7-15
LODA
removal and replacement, 4-30
troubleshooting, 12-6
LO distribution amplifier, 7-43, 11-23
removal and replacement, 4-30
LO distribution amplifier troubleshooting, 12-6
log amplifier
adjustments, 2-30
detector/mixer troubleshooting, 9-20
failures, 9-13
input switch troubleshooting, 9-19
isolation amplifier troubleshooting, 9-20
limiter troubleshooting, 9-20
troubleshooting, 9-13
Log amplifier, 7-48
log check, 7-14
log expand functions, 7-49
log expand troubleshooting, 8-15
log fidelity adjustment, 2-33
log gain compensation troubleshooting, 9-20
log offset compensation troubleshooting, 9-20
log offset troubleshooting, 8-15
LO span problems, 11-40, 11-41
LO switch troubleshooting, 9-19
low and high band problems, 12-5
low band mixer, 7-43, 12-7
removal and replacement, 4-31
low band problems, 12-4
low-pass filter troubleshooting, 9-38
low voltage supplies, 13-15
M
main chassis parts, 5-17, 5-25
main coil, 11-29
manual frequency response adjustment, 2-43
manual probe troubleshooting, 7-15
manufacturers code list, 5-6
marker problems, lo-13
mass storage
frequency response adjustment software, 3-10
mass storage file, 3-7
mass storage location, 3-6
mechanical parts, 5-17, 5-25
memory for frequency response adjustment
software, 3-2, 3-6
microprocessor. See controller
MISSING ETE software message, 3-10, 3-11
mixer amplitude adjustment, 2-57
mixer bias adjustment, 2-56
Index-5