HP 8593A

PEAK SEARCH places a omarker on the higinest amplitude of a trace, amuml
displays the marker’s amplitude and freqnency. HP 8592i1 omm/y.
LPnAK 5EARPA) places a uuuarker on tine highest amplitude of a trace, displays
the marker’s amoplitude and fremuuenry, and accesses the peak searcin softkey
menu.
PK—PK MEAS flnds and displays tine frequency and aunphtude differemuces
between tine inighest and lowest sigmuals.
PLOT CONFIG accesses time softkey nuenu that is used to address the plotter
and to select from jmlotter options. Optiomu 021 or 023 0mm/p.
PLOTTER ADDRESS allows yon to select time ilP-IB amlmi mess of time imlotter.
Optiomm 021 or 023 only.
PLT__LOC__ allow’s you to select time lom:ation (our time page) of a plotter
outpnt. (This key appears ommls’ if two or four plots per page are selectemi
using PLTS/PG t 2 4 .) Option 02/ or 023 only.
PLTS/PG 1 2 4 allow’s yomu to choose a full-page, imaif-page, or qumarter-page
plot size. Option 021 or 023 only.
POINT specifies a hinmit value for time coordinate point and out-of-caurge
values for time rest of tine liumnit-line segmnemmt.
POWER ON IP LAST determnines time state timat time spectrnnmn analyzer a-ill he
in when time spectrummm analyzer is posvered oum. If POWER ON IP LAST is set
to
11m (111 is undcrlineml). time state of tine smnectrumn analyzer is tine sanmme as it
is after [ggy Tj is pressed. if POWER ON IP LAST is set to b,AST (LAST is
our miemhined), time state tire spectrmu no a mmaly’zc!r was inn wimeum it was luowememi mmff
is recalled.
PRESEL DEFAULT provides a swept flatness response svithomut preseiector
peaking. PRESEL DEFAULT muses the correctionfactors gemmerated fromu the
CAL YTF self-cahbratiomm rontiume. uP 8592B, HP 8593.4, or iii’ 85954
our/p.
2-16 Spectrum Analyzer Functions