HP 8593A

Note P reselector peak operates iii the p reselected ban us ( ha iii 1 to
1) only.
PRESEL PEAK automaticallyadjusts the preselector to nuaxi nuize the
amplitude at the position of the marker. lIP 8592/3, 111’ 859.3.4, or
II? 8395~l oiulmj.
[P~ESET) retu Ins the spectru in analyzer to a known state, accesseS lie soit Rev
menu of avail able spec truru analyzer nodes,arid perforinis a processor test
P lIES ET does not affect the correction factors. I’ If ES L a ISO clears hot Ii
the input and out nit buffers, arid turnsoff lie amiuplitude correction factors
and the limit—line testing.
PRESET SPECTRUM allows only the spectrum a nualyzer iooulu’ to he preset:
it will itot a fleet I lie ot her operat lug node,,. PRESET SPECTRUM provider- a
convenient starting pointfor most measurements; it performs a sritset of tIre
froici ions that [PRESET] performs. Refer to the Operation Manual for a list of
the fnnictiorts that PRESET SPECTRUM performs.
PRINT CONFIG accesses t lie softRev menu that is used to address tIre pci liter
arid select from either a black arid white print ora color print. (A color print
requi lena Ii hP Psi ut Jet printer.) Option 02/ or 023 only.
PRINTER ADDRESS allows you to select the II P-I B aulil ress of the pri it or.
Option 02/ only.
PRINTER SETUP resets t lie printer, sets the Ii lies per Page (i liP, a nil set s liii
printer to skip page perforations. Option 091 or 02.1 only.
PRT MENU ON OFF allows tIme softkey lahuehs to be printed when von ace iii
to pri it t lie dir- p
1rty. Opt non 091 or 02.3 only.
PURGE AMP CUR clears the current a mph I nil e correct ion factors from n
spectra nun analyzer irielniory.
PURGE LIMITS clears the current Ii nut—line table fronu spectruin analyzer
memory.
Spectrum Analyzer Functions 2-17