HP 8593A

SCALE LOG LIN sets the vertical scale to eitlmer log or linear aund, w’ineur mm
log setting, activates log scale per division.
SECAM—L triggers oum time SECAM-L video formats. Options 101 nnd 102, or
Option 301 only.
SELECT AMPLITUD (froun the Auoplitude Correction omenu) allow-s you to
enter or emlit the amplitude value for an aomplitnde correction factcnr. Wlmemu
accessed from the Limit-Line menu, SELECT AMPLITUD allows yon to eumtm’r
or edit time anmplitude value for the displayed (upper or lnmwer) liunmit-linme
segmemut.
SELECT OLT AMPL allows you to enuter the delta annplitmmde valmme. The
ummid- aunmpli tunde valmue aumnl time mini ta anmu imlitmude s’almme create tIre u tmtmer mm mmml
lower limit-line tableentries.
SELECT FREQ (fronmu time Amplitmude Correctioum unenu) ailosvs you to eater mmr
edit the frer~nmency for an ammmplitude correction factor. ~Vlmemm accessed fromu
tIne Li unit— Lime unenmu , SELECT FREQ al lmssvs vomm tnm custer time fremi uneunry sal nrc
for a Inunit-line segment.
SELECT LWR AMPL allows you to enter the amn
1mlitude vaimne for time lower
Ii numit—li nmm’ segumnenut -
SELECT MID AMPL allow-s you to enter the ummid-amnplitmnde valmme. ‘lire
ummini—amumpli tmmmie s’almme aurd time delta amnphtmmdm’ s’almme create time mm mimer aurd
lower Ii ummit-linme table eumt ries.
SELECT POINT allow’s yomu to create oredit an annmplitmmnle correctionu fartmmr.
SELECT PREFX cinanuges the crurrent prefix to the prefix of tIne selected Lie.
SELECT SEGMENT allow’s yomu to create oredit a linmit-line segmumemut.
SELECT TYPE accesses the softkey muetmu timmst is used fmmr selecilmug time type
of liomit line: a flat line (FLAT), a sloped line i SLOPE ), or a poimnt ) POINT ).
SELECT UPR AMPL allow-s youu to eunter time anmplitude value for tine upper
ii nu I t-linme segnneumt -
Spectrum Analyzer Functions 2-19