397
Chapter 7, IBASIC Controller
Interfacing to the IBASIC Controller using Serial Ports
Terminal Configuration
Use the cable information in table 38 on page 385 and figure 25 on page 386 for
connecting to an external terminal. Terminals typically have a DB-25 (male)
connector. Set the terminal for DEC VT-100 ANSI emulation. Many ASCII
terminals will also function properly.
To set up the terminal, use the field settings found in the HP AdvanceLink
terminal emulator section found earlier in this chapter. As a minimum, make sure
the terminal’s basic setup information matches the fields on the Test Set’s I/O
CONFIGURE screen (refer to
table 40 on page 389 for recommended settings).
To Next Page
Loading...
