466
Chapter 8, Programming The Call Processing Subsystem
Using the Call Processing Subsystem’s Remote User Interface
Accessing the Call Processing Subsystem Screens
The Call Processing Subsystem screens are accessed by selecting the CALL
CONTROL
, CALL DATA, CALL BIT, CALL CONFIGURE, ANALOG MEAS, or
AUTHENTICATION
screens using the :DISPlay command. The mnemonics used to
select a particular screen with the DISPlay command are shown in table 43.
The query form of the :DISPlay command (that is, :DISPlay?) can be used to
determine which screen is currently displayed.
Syntax
:DISPlay <screen mnemonic>
:DISPlay?
Example
OUTPUT 714;"DISP ACNT"
OUTPUT 714;"DISP?"
ENTER 714;Screen$
Table 43 Call Processing Screen Mnemonics
Screen Mnemonic
CALL CONTROL ACNT
CALL DATA CDAT
CALL BIT CBIT
CALL CONFIGURE CCNF
ANALOG MEAS CME
AUTHENTICATION AUTH
DIGITAL
MEASUREMENTS
DME
To Next Page
Loading...
