HP 8920B - Page 492

492
Chapter 8, Programming The Call Processing Subsystem
Programming The CALL CONTROL Screen
DSAT:−
The DSAT: field (NAMPS system type only), located in the voice channel
assignment field is divided into two fields:
• The left-hand field displays the current DSAT control message being broadcast by the
base station. A numeric value is only displayed when the Ch Loc: is set to Lower,
Middle or Upper and a mobile station is actively connected on a voice channel (that is,
the Connect annunciator is lit). A “-” is displayed if a mobile station is not actively
connected on a voice channel or the Ch Loc: is set to Wide. When the Ch Loc: is
set to Wide the SAT field displays the current SAT frequency being broadcast by the
Test Set.
The left-hand field is a read only field and is displayed only when the selected system
type is NAMPS.
The :DSAT:ACTual? query command is used to query the contents of the left-hand
field.
There is no command form of the query :DSAT:ACTual? .
Syntax
:DSAT:ACTual?
Example
OUTPUT 714;"CALLP:NAMP:DSAT:ACTual?"
ENTER 714;Active_dsat$
• The right-hand field (highlighted field) is used to set one of the 7 valid DSAT sequences
to be used on the designated voice channel (the channel number entered into the Chan:
right-hand field).
The :DSAT command is used to control the right-hand field.
The query form of the command (that is, :DSAT:SETTing?) can be used to determine
the current Test Set DSAT setting.
Syntax
:DSAT:SETTing <’><0 2556CB/1 255B2B/2 256A9B/3 25AD4D/4 26AB2B/5 26B2AD/6
2969AB><’>
:DSAT:SETTing?
Example
OUTPUT 714;"CALLP:NAMP:DSAT ’0 2556CB’"
OUTPUT 714;"CALLP:NAMP:DSAT:SETT?"
ENTER 714;DSat_sequence$