HP 8920B - Page 494

494
Chapter 8, Programming The Call Processing Subsystem
Programming The CALL CONTROL Screen
ESN (hex):
This information string displays the electronic serial number (ESN), in
hexadecimal form, received from the mobile station on the reverse control
channel in response to a forward control channel message.
The
ESN (hex): field is only displayed when the Display field is set to Data
and a reverse control channel message containing this information has been
decoded.
Refer to the
Display field description, on page 483, for information on how to
read data displayed in the upper right hand portion of the CALL CONTROL screen.
FM Deviation
This field displays the measured FM deviation of the RF carrier being transmitted
by the mobile station on the reverse voice channel. Four dashes (----) indicate that
no carrier is present to measure.
A numeric value would only be displayed in the connected state (that is, the
Connected annunciator is lit). The FM Deviation field is only displayed when
the Display field is set to Meas.
Refer to the
Display field description, on page 483, for information on how to
read measurement results from this field.