HP 8920B - Page 517

517
Chapter 8, Programming The Call Processing Subsystem
Programming The AUTHENTICATION Screen
NEW The :SSDA:NEW command is only available through the remote users interface.
No field is displayed for this function on the test set. This value can be used during
authentication to replace or query the SSD-A_NEW value in the Test Set.
The :SSDA:NEW value is the most significant 64-bits of the SSD value stored in
the mobile station. SSDA:NEW is entered as a 16-digit hexadecimal value.
The query form (that is, :NEW?) can be used to query the current Test Set value.
Syntax
:NEW <‘><16 character hex value><‘>
:NEW?
Example
OUTPUT 714;"CALLP:AMPS:AUTH:SSDA:NEW ‘1234567890ABCDEF’"
OUTPUT 714;"CALLP:AMPS:AUTH:SSDA:NEW?"
ENTER 714;Ssda_new_val$
SSDB
The :SSDB command is only available through the remote users interface. No
field is displayed for this function on the test set. The user can enter a valid value
into the Test Set along with other necessary shared secret data to avoid the SSD
Upd process at the start of testing to reduce testing time.
SSDB is the least significant 64-bits of the SSD value stored in the mobile station.
SSDB is entered as a 16-digit hexadecimal value.
The :SSDB command is used to control this field.
The query form (that is, :SSDB?) can be used to query the current Test Set value.
Syntax
:SSDB <‘><16 character hex value><‘>
:SSDB?
Example
OUTPUT 714;"CALLP:AMPS:AUTH:SSDB ‘1234567890ABCDEF’"
OUTPUT 714;"CALLP:AMPS:AUTH:SSDB?"
ENTER 714;Ssdb_val$