518
Chapter 8, Programming The Call Processing Subsystem
Programming The AUTHENTICATION Screen
NEW The :SSDB:NEW command is only available through the remote users interface.
No field is displayed for this function on the test set. This value can be used during
authentication to replace or query the SSD-A_NEW value in the Test Set.
The :SSDB:NEW value is the least significant 64-bits of the SSD value stored in
the mobile station. SSDA:NEW is entered as a 16-digit hexadecimal value.
The query form (that is, :NEW?) can be used to query the current Test Set value.
Syntax
:NEW <‘><16 character hex value><‘>
:NEW?
Example
OUTPUT 714;"CALLP:AMPS:AUTH:SSDB:NEW ‘1234567890ABCDEF’"
OUTPUT 714;"CALLP:AMPS:AUTH:SSDB:NEW?"
ENTER 714;Ssdb_new_val$
1 of N
The 1 of N field instructs the Test Set how many times to repeat a system
parameter overhead message. The message contains RAND values, RAND_A and
RAND_B. The RAND values are difficult for phones which do not support
authentication to parse. This field allows for testing of these phones along with the
testing of phones which support authentication by altering the number of times the
system parameter message is sent to the mobile station.
Syntax
:OON <integer>
:OON?
Example
OUTPUT 714;”CALLP:AMPS:AUTH:OON 2”
OUTPUT 714;”CALLP:AMPS:AUTH:OON?
ENTER 714;Oon_set$
To Next Page
Loading...
