547
Chapter 8, Programming The Call Processing Subsystem
Programming The CALL BIT Screen
For example: changing the value of the SAT color code field (SCC) in the forward
control channel mobile station control message (MS IntVCh) does not change the
setting of the SAT: field on the CALL CONTROL screen.
When using the CALL BIT screen the user is responsible for setting the contents
of all messages used in a messaging protocol. When using the CALL BIT screen
the Call Processing Subsystem host firmware sends the correct message(s) at the
correct time(s) as defined in the applicable industry standard. Message content is
the responsibility of the user.
Using the CALL BIT screen requires expert knowledge of the call processing
messaging protocols used in the selected system (that is, the system selected in the
System Type field on the CALL CONTROL screen).
To Next Page
Loading...
