HP 8920B - Page 559

559
Chapter 8, Programming The Call Processing Subsystem
Programming The CALL BIT Screen
Modifying the CALL BIT Screen Message Fields
This section provides programming information on how to set the contents of
individual fields in the signaling messages available on the CALL BITS screen.
The syntactical structure for setting the contents of a field in an individual
message is as follows:
General Syntax’
CALLP:<message name>:<field name><space><’><data string><’>
Table 50, "CALL BIT Screen Signaling Message Names" on page 559 lists the
message names used to access each of the signaling messages available on the
CALL BIT screen.
Table 50 CALL BIT Screen Signaling Message Names
Message Message Name
SPC WORD1 SPOM1/SPOMESSAGE1
SPC WORD2 SPOM2/SPOMESSAGE2
ACCESS ACCess
REG INC RINCrement
REG ID RIDentify
C-FILMESS CFMessage
MS WORD1 MSWord
MSMessOrd MSORder
MS IntvcH MSVoice
FVC O Mes FVORder
FVC C Mes FVVoice
RandChalA RCA
RandChalB RCB
RAND SSD1 RSSD1
RAND SSD2 RSSD2
RAND SSD3 RSSD3