HP 9000 300 Series - Page 72

7 Open the grounding wrist strap
kit, unfold the strap and attach
its copper end to your
controller's chassis.
The sticky black end attaches
to your wrist.
8 If you do not need to remove
RAM boards, skip
to step 9. If
you need to remove RAM
boards:
a. Remove
the
highest-numbered (towards
the front) RAM board first.
Pushing its two slot clips
out, then tilt its top away
from the board next to it.
b. Remove
the next
lower-numbered RAM
board
next to the one just
removed.
c. Remove the remaining RAM
boards you need to remove.
5
Memory Configurations 5-23