R
robert12Jul 31, 2025
How to fix HP 971A that won’t turn on?
- MmillerrobertJul 31, 2025
If your HP Multimeter won’t turn on, the batteries may be dead. Replace the batteries to resolve this.
To Next PageTo Next PageHow to fix HP 971A that won’t turn on?
If your HP Multimeter won’t turn on, the batteries may be dead. Replace the batteries to resolve this.
Why does my HP 971A Multimeter display flash and beep rapidly?
A flashing display and rapid beeping on your HP Multimeter can occur for a couple of reasons: * The input limit may have been exceeded. If so, remove the test leads and press any key to reset. * The test leads might be in the wrong terminal for the measurement function. Try changing the test leads or the function switch position.
What to do if HP Multimeter won’t turn off?
If your HP Multimeter won’t turn off, it's possible that the input limit has been exceeded. Remove the test leads and press any key to reset the device.
Why is the battery annunciator on my HP 971A on?
If the battery annunciator is on, it means the battery voltage is low. Replace the batteries in your HP Multimeter.
General| Brand | HP |
|---|---|
| Model | 971A |
| Category | Multimeter |
| Language | English |
Explains the meaning of safety symbols used in the manual.
Details maximum voltage limits for safe operation and potential damage.
Guidelines for inspecting and using test leads to ensure safety.
Lists the necessary test equipment for calibration.
Step-by-step instructions for calibrating the multimeter.
Common problems, their causes, and suggested solutions.
Detailed specifications for DC voltage measurements.
Specifications for AC voltage measurements.
Detailed specifications for DC current measurements.
Table outlining calibration steps, input signals, and tolerances.
