11-1
I
I~
I 9845B/C Mainframe Service Notes I
tu1
Service Notes
will
be published in
Support
Update. They are printed
in
reduced size for placing
in
this binder. Remove them from the
Support
Update, punch them
and
pi
ace them behind
this page.
How
to
Punch
the
Service
Notes
A problem arises
in
that six-hole punches are not widely available. The Service Notes may
either be punched with a hand punch, or a three-hole punch may
be
adjusted to punch the
Handbook pattern.
To modify a three-hole punch to punch the Handbook hole pattern, follow these directions:
1.
Most punches have an inch scale to position the individual punches. This scale has zero in
the middle, and increases to the left
and
right. Move the individual punches to the 1
7
/8,
2%
and
3%
positions. The punches can be on either the left
or
the right (or any combina-
tion) as long as each number has a punch on
it.
2.
Center the page to be punched on the scale. That
is,
put the left edge on the same
number on the left scale as the right edge
is
on the right scale. For an
8112
inch page this
will
be
41f4.
3.
Punch the page, then turn
it
over, center
it
and punch
it
a second time.
I
To Next Page
Loading...
Need help?
General
