HP 9845B/C CE User Manual

5-16 9845B/C Diagnostics
k15 Return To Operational System, 98458/C Opt. ZXX
Note
This test
is the only valid bit-slice processor test.
When the k15 return to system SFK is pressed and the AUTOST key is latched, the lPU
processor and ROM checksum tests are performed. At that point, an AUTOST file is brought in
to run the BIT -SLICE processor tests as desired.
Entry point for the Bit Slice Microcode test
is either from k15 by answering yes to conduct bit
slice microcode tests,
or by doing a lOAD "AUTOST", 1 with TBIN in.
Note
If the AUTOST key is unlatched, the message "Autost must be latch-
ed before returning to the system" is displayed. When the AUTOST
key is latched the Autost file will be brought in.
If CTl STOP is pressed after the 9845B/C has returned to normal operation and the Test ROM
is installed, the Test ROM turnon test will run and the mainframe is back in the diagnostic mode.

HP 9845B/C CE Specifications

General

Brand	HP
Model	9845B/C CE
Category	Storage
Language	English