Reference 39
SCR Reference (man Pages)
scr (5) - Track Configuration Changes with SCR
# scrdiff node1:latest node2:latest
[BASE] node1 : 04/10/1999 13:25 PDT (latest)
[TARGET] node2 : 04/10/1999 13:05 PDT (latest)
No filter applied.
COMPONENT NAME BASE TARGET
GROUP NAME
ATTRIBUTE NAME
"HP-UX Standard Groups Definition"
"Host Processor"
[Host Processor Index] 1 1
* [Processor Firmware ID] "HP PA RISC1.1" "HP
PA RISC2.0"
[Processor Load] 1 1
* [Host Processor Index] - 1
* [Processor Firmware ID] - "HP
PA RISC2.0"
* [Processor Load] - 1
:
The output describes a processor difference: base node1 is a PA 1.1
single processor model, and target node2 is PA2.0 multi processor
model.
View configuration information by time and managed node with the
scrviewer command, which lists one set of configuration
information at a time on a node.
# scrviewer node2:latest
node2 : 04/10/1999 13:05 PDT (latest)
No filter applied.
COMPONENT NAME VALUE
GROUP NAME
ATTRIBUTE NAME
"HP-UX Installed Software Definition"
:
"HP-UX Standard Groups Definition"
:
"General Information"
[System Name] node2
[System Location] W-206
:
To Next Page
Loading...
Need help?
General