Configuring the console switch 38
2.
Select the DNS Assignment Mode:
o Manual
o BOOTP
o DHCPv6
3. Enter the DNS server addresses in the Primary, Secondary, and Tertiary fields.
NTP settings
To configure NTP settings:
1. Select Unit View>Appliance>Appliance Settings>NTP. The NTP page appears.
2. To enable NTP, select the Enable NTP checkbox.
3. Enter the name/address of the NTP servers in the NTP Server 1 and NTP Server 2 fields.
4. To enable the update interval, select the checkbox, and select the number of minutes for the update
interval.
SNMP settings
SNMP is a protocol used to communicate management information between network management
applications and the console switch. Other SNMP managers can communicate with your switch by
accessing MIB-II and the public portion of the enterprise MIB. You can designate which stations can
manage the switch as well as receive SNMP traps from the switch. If you enable SNMP, the console
switch responds to all SNMP requests over UDP port 161.
To configure your SNMP settings:
To Next Page
Loading...
Need help?
General
