Commands
PBM PBM module
IOR PCI IO riser
DUO DUO module
CMM CMM module
VRMn.CPU VRM (n = 0-5) for CPUs
VRMn.RIMM VRM (n = 0-4) for RIMMs
VRM0.TERM VRM for terminator
RIMMnc RIMMs (n = 0-9 for slot
number, c = 0-1 for CPU
processor number)
PSn PCI power supply (n = 0-1)
PWRn Power supply tray (n = 0-1)
of SBB
PWRn.PSp Power supply of SBB
CLM Common Logic Module (of
Superdome PS subsysem)
DUO, CMM, VRM and RIMM require the additional
qualifier “-duo” to indicate the residency.
part_num FRU’s part number. This field contains the FRU revision.
(This is a 16-character ASCII string with no embedded
spaces.)
serial_num FRU’s serial number. This ASCII string must be 10
characters.
model The FRU’s model name or number or alias. This ASCII
string may be up to 10 characters. This field is optional and
does not apply to third-party FRUs.
offset The beginning byte offset inhex within this FRU's
EEPROM, where the following data bytes are written.
byte... Up to 16 data bytes to be written. At least one byte must
be supplied after the offset.
Options
-cabinet <cabinet> Cabinet number in hex. If not specified, defaults to 0.
-drawer <drawer> Drawer number in hex. If not specified, defaults to 0.
-duo <duo> Dual-CPU module number in decimal.
-s Write raw data to the EEPROM. Used to apply any
FRU-specific data. Checksum is automatically
updated after the raw data is written.
-rimm Build a unique serial number across all RIMMs. The
RIMM number is based on the 12-character system
serial number concatenated with a 4-digit sequence
number determined by the RIMM's location. These
four digits, CDSI, are defined as:
C - Cabinet number 0 - 7
D - Duo number 0 - F (ASCII hex). It is calculated by
(drawer_num * 4 + duo_num)
S - RIMM slot 0 - 9 for CPU0, RIMM0-9; and A - J for
CPU1, RIMM0-9>
I - Insertion count (ASCII 0-9, then A-Z)
3-9
To Next Page
Loading...
Need help?
General