Commands
2. Set up configuration register 0 of LM80 on the MBM I
2
C bus, PS controller 1, sub bus 0
with the iic address of 50 hex.
MBM> deposit -ca 0 -dr 3 pbm -iic 1/0/50 0 7
3. Write to the MBM memory space
MBM> e -ca 0 -dr 2 mbm 20 -n 3 –pmem # examine MBM memory space 0/2/mbm/pmem:
20 FC
0/2/mbm/pmem: 21 D3
0/2/mbm/pmem: 22 20
0/2/mbm/pmem: 23 00
MBM> deposit * e0 –n 3 # write to MBM memory space
MBM> e * -n 3
0/2/mbm/pmem: 20 E0
0/2/mbm/pmem: 21 E0
0/2/mbm/pmem: 22 E0
0/2/mbm/pmem: 23 E0
MBM>
See Also
examine, e
3-29
To Next Page
Loading...
