CAUTION: Two people are required to lift and install the I/O drawer in the cabinet.
Estimated weight of the drawer is 143 kg (65 lb).
1. Align one outer slide half such that the slots for the screws in the slide half are
centered horizontally and vertically with respect to the screws. Then tighten the
screws.
2. Position the other outer slide half so that it can freely engage the inner slide half of
the drawer on that side. Do not tighten the screws for this slide half yet.
3. At the rear of the cabinet, lift and rest the front of the I/O drawer onto the outer
slide halves, making sure the inner and outer halves of the slides are aligned. With
the drawer horizontally and vertically aligned with respect to the direction of
installation, carefully slide the drawer to the front of the cabinet.
4. Once the drawer is aligned and can slide freely, tighten the screws on the loose
outer slide half.
Cabling 3-11
To Next Page
Loading...
Need help?
General