~GRP-W-(grp_Probe) Use Set Membership -add -ca 1 -dr 6 PBM
6 pbm
[
~GRP-E-(grp_IAmAlive) MISSING NEIGHBOR timeout from Cab: 1, Drawer: 7
Cab Drw Module MicroID IP Address In Group
0 0 MBM 100000a 10.0.0.1 TRUE
0 1 MBM 100010a 10.1.0.1 TRUE
0 2 PBM 2fe0a 10.254.2.0 TRUE
1 3 PBM 103fe0a 10.254.3.1 TRUE
1 4 PBM 104fe0a 10.254.4.1 TRUE
1 5 PBM 105fe0a 10.254.5.1 TRUE
1 6 PBM 106fe0a 10.254.6.1 FALSE
1 7 ~GRP-W-(grp_IAmAlive) Leaving Group ID: 100010a.9
PBM ~GRP-W-(grp_Crea107fe0ate) Joined Gr oup ID: 100000a.b
10.254.7.1 TRUE
MBM> [2003/07/16 07:29:11]
~REC-W-(trecTask) Server management group is transitioning.
interrupt: ~GRP-I-(interrupt), GROUP HAS FORMED ID:100000a.b
interrupt: ~GRP-I-(interrupt), GROUP IS STABLE ID:100000a.b
[2003/07/16 07:29:34]
~REC-W-(trecTask) Server management group is stable.
\
Restore power to the system. You will receive a series of error messages. This is to be
expected, since the console is identifying a component not yet configured into the system
network.
1. After you return power, the system begins its software power-up. Server management
discovers any newly added drawers and reports them to you. In this case, server
management has discovered a drawer in cabinet 1, drawer 6.
2. Server management tells you what command to run to include this newly discovered
drawer.
Y
3. The system continues to power up. All during its power-up sequence it continues to
broadcast the information shown at
X and Y until you provide manual intervention to
include it in the group.
4. Type in the command
set membership –add –ca 1 –dr 6 PBM. In this case,
the system continues to broadcast messages while you type in the command.
5. When this message appears, server management has accepted the command.
Configure and Troubleshoot 4-3
To Next Page
Loading...
Need help?
General