HP b2600 Supplementary Guide

Chapter 1 43
Remove/Replace System Components
Removing/Replacing System Components
4. Unscrew the four power supply mounting screws located on the back of the system. See
Figure 1-48. Note that there is a power supply support arm that fits into a slot on the
system divider panel. This support arm prevents the supply from falling onto the
system board while you are unscrewing the mounting screws.
Figure 1-48. Unscrewing the Four Power Supply Mounting Screws
5. Remove the AC power supply from the system. To do this, you will have to slide the
support arm out of its slot. See Figure 1-49. Note that there is a component heat sink
located on the system board near the back of the power supply that can be damaged if
you are not careful when removing the power supply. See Figure 1-49.
Figure 1-49. Removing the AC Power Supply
Power Supply
Support Arm
Power Supply Mounting Screws
System Divider
Panel
AC Power Supply

HP b2600 Specifications

General

Brand	HP
Model	b2600
Category	Desktop
Language	English