ENWW The HP Jetdirect Control Panel Menu 278
SSID: Choose one of the following selections:
â– hpsetup (default): This is the factory-default setting. It may
be displayed in uppercase characters on most control
panels, but is actually lowercase.
â– <List of SSIDs>: Select from a list of SSIDs detected by the
print server.
â– <AUTO>: The print server will automatically detect SSIDs
and attempt to connect and authenticate on a network,
starting with the SSID network with the best signal strength.
â– <CUSTOM> to enter a new SSID.
CFG SSID: This item appears if SSID=<CUSTOM> was set. At
the SSID= prompt, enter a custom SSID, one character at a
time. This SSID will be added to the SSID list. If you
subsequently enter a new SSID, it will overwrite the existing
custom SSID.
AUTH.: Choose one of the following authentication methods for
your network:
â– OPEN (default) to select Open System
â– SHARED to select Shared Key
â– EAP to select among supported IEEE 802.1x Extensible
Authentication Protocol (EAP) options that use an
authentication server. See the CFG EAP menu.
â– PSK to select Extensible Authentication Protocol (EAP)
using a Pre-Shared Key (PSK) on networks where an
authentication server is not used. See the CFG PSK menu.
CFG PSK: This item appears if AUTH.=PSK was set. Choose
one of the following and select it:
NO (default): Bypass PSK configuration.
YES: Continue with PSK configuration. Enter a network
pass-phrase that will be used to generate the Pre-Shared Key
for EAP authentication on your network.
At the PHRASE= prompt, enter a pass-phrase one character
at a time. A pass-phrase must be from 8 to 63 ASCII characters
in the hexadecimal range 21 through 7E (characters 0-9, a-z,
A-Z and numerous special characters including !, @, #, $, %,
^, &, (, ), _, +, =, -, {, }, [, ], \, /, “, <, >, ?, “, ‘, ~).
Table C.1 HP Jetdirect Classic Control Panel Menu (2 of 6)
Menu Item Description
To Next Page
Loading...
Need help?
General
