12
3 Using the Car Camcorder
3.1 Automatic Record
Start the car engine, wait a few seconds to charge the camcorder,
and then screen will light up and the camcorder will automatically
power on and start recording.
Recording will automatically stop when the engine is switched off.
Note:
1. Some vehicle power supply would not turn on / off automatically with the car engine
start, if the camcorder cannot automatically power on/off with the car engine, please
manually connect the power supply with the vehicle power, and then power on, or manually
power off the camcorder and then release the connector with the car power supply.
2. It can be configured to save a video file for every 30 seconds, 1 or 3 minutes of recording.
3. All the videos and photos are saved in the memory card, if memory card is full, loop
recording will generally overwrite the oldest video file.
4. The camcorder is built-in super capacitor. After start the car engine, please wait a few
seconds for charging the camcorder, and then the camcorder will automatically power on
and start recording.
3.1.1 Emergency Recording
To Start the Emergency Recording,
do the following:
1. During Video Recording, press the
OK
button to enter emergency
recording mode, the
“Emergency” message will be
shown immediately on the upper
left corner of the screen, and the
recorded file will be protected.
To Next Page
Loading...
