message. When printing a very complicated document, increase this value. If you specify 0 seconds,
the product waits indefinitely. The default setting is 300 seconds. Use the spin box to change this value,
up to a maximum of 32,767 seconds (that is, approximately 9 hours).
Minimum Font Size to Download as Outline
This control specifies the minimum font size (in pixels) for which the printer-driver downloads TrueType
fonts as outline (Type 1) fonts. Any font smaller than the minimum setting is downloaded as a bitmap
(Type 3) font. Use this option to fine-tune the Automatic setting for the TrueType Font Download
option on the Advanced tab in Document Defaults. The default setting is 100 pixel(s). Use the spin
box to change this value, up to a maximum of 32,767 pixels.
Maximum Font Size to Download as Bitmap
This control specifies the maximum font size (in pixels) for which the printer-driver will download
TrueType fonts as bitmap (Type 3) fonts. Any font larger than the maximum setting will be downloaded
as an outline (Type 1) font. Use this option to fine-tune the Automatic setting, or to override the Send
TrueType as Bitmap setting for the TrueType Font Download option on the Advanced tab in
Document Defaults. The default setting is 600 pixel(s). Use the spin box to change this value, up to
a maximum of 32,767 pixels.
Postscript Passthrough
Postscript Passthrough is enabled by default, and must be enabled for most print jobs. Postscript
passthrough provides additional capabilities for some software programs when printing to a postscript
printer-driver. Options such as Watermarks, Pages per sheet and Booklet Printing might not print
correctly from some software programs when Postscript Passthrough is enabled, because such
programs send postscript information that the printer-driver cannot control. Other programs might print
using these options without problems. Select Disabled and print the document again if you encounter
problems.
NOTE: In some cases, disabling Postscript Passthrough can cause unexpected results within a
software program.
JPEG Passthrough
The JPEG Passthrough setting contains the following options:
●
Disable. When this option is selected, images that are sent as .JPEG are printed as bitmaps,
resulting in faster printing.
●
Enable. When this option is selected, images that are sent as .JPEG are printed as .JPEG (.JPEG
passthrough).
●
Auto. (This is the default.) When this option is selected, the product connection type is
automatically detected. For network (TCP/IP) connections, the JPEG Passthrough setting is
disabled. For DOT4 and USB connections, the JPEG Passthrough setting is enabled.
210 Chapter 4 HP PCL 6 and universal printer-drivers for Windows ENWW
To Next Page
Loading...