EN
Control panel messages
21
1
Media is jammed in the transfer belt area or media is not picking.
• Open the ITB drawer and remove any jammed media.
• Watch the pick roller to ensure it is turning.
• Check for media between the transfer roller and the fusing assembly.
Media is jammed in the front duplexing area.
• Open the front duplex drawer and remove any jammed media.
A jam has occurred inside the ITB drawer area. The jam may be located
in the fuser area or between the transfer area and the fuser.
1
Open the ITB drawer and carefully inspect for any media.
2
Be sure to inspect the fusing area. You may need to access the
fusing area through the rear door.
3
Remove any jammed media.
More data has been received from the computer than fits in the printer’s
internal memory.
1
To continue printing, press
G
O
. Only the amount of data that fits in
the printer’s internal memory is printed.
2
To cancel the job, press
C
ANCEL
J
OB
.
3
Add more memory to resolve the problem.
13.xx Paper jam
alternates with
Check middle front doors
13.xx Paper jam
alternates with
Check front duplex drawer
13.1 Paper jam open middle front drawer
alternates
with
Check in rear of drawer
20 Insufficient memory
alternates with
Press Go to continue
To Next Page
Loading...