22 Chapter 1 Troubleshooting control panel messages
EN
The EIO buffer for the EIO card in slot “x” has overflowed during a busy
state.
• The current data in the print buffer will be lost.
• Press G
O
to resume printing and then resend the job.
This message indicates that the parallel buffer has overflowed.
• The current data in the print buffer will be lost.
• Press G
O
to resume printing and then resend the job.
A connection with the card in the specified slot has been broken.
1 Check that all cables are connected to the EIO ports and that the
EIO board is seated properly.
2 If possible, print to another network printer to verify that the network
is working properly.
Note
All data in the print buffer will be lost.
A tray is configured for a specific paper size, but the sheet loaded is a
different size. This error often occurs when the printer is multifeeding.
• Load the tray with the requested size media.
22 EIO x buffer overflow
alternates with
Press Go to continue
22 Parallel IO buffer overflow
alternates with
Press Go to continue
40 EIO x data error
alternates with
Press Go to continue
41.3 Unexpected paper size
alternates with
Check paper in Tray x
To Next Page
Loading...