6. Reconnect the power cable and remaining interface cables, and turn the product on.
7. Print a configuration page. An HP Jetdirect configuration page that contains network configuration
and status information should also print.
If it does not print, turn the product off, and then uninstall and reinstall the print server card to ensure
that it is completely seated in the slot.
8. Perform one of these steps:
●
Choose the correct port. See the computer or operating system documentation for
instructions.
●
Reinstall the software, choosing the network installation this time.
28 Chapter 3 Manage and maintain the product ENWW
To Next Page
Loading...
