To Next Page

To Previous Page

4 Removal and replacement procedures

Preliminary replacement requirements

Tools required

You will need the following tools to complete the removal and replacement procedures:

●

Flat-bladed screwdriver

●

Hex 5.0-mm nutdriver

●

Magnetic screwdriver

●

Phillips P0 and P1 screwdrivers

●

Torx T8 screwdriver

Service considerations

The following sections include some of the considerations that you must keep in mind during

disassembly and assembly procedures.

NOTE: As you remove each subassembly from the computer, place the subassembly (and all

accompanying screws) away from the work area to prevent damage.

Plastic parts

Using excessive force during disassembly and reassembly can damage plastic parts. Use care when

handling the plastic parts. Apply pressure only at the points designated in the maintenance instructions.

Preliminary replacement requirements 39

Other manuals for HP COMPAQ 6510B

Questions and Answers:

Need help?

Do you have a question about the HP COMPAQ 6510B and is the answer not in the manual?

General