To Next Page

To Previous Page

Display assembly

Description Spare part number

14.1-inch, WXGA+ display assembly for use only with HP Compaq 6515b computer models with

WWAN capability

443895-001

14.1-inch, WXGA+, BrightView display assembly for use only with HP Compaq 6515b computer

models without WWAN capability

443894-001

14.1-inch, WXGA+ display assembly for use only with HP Compaq 6515b computer models without

WWAN capability

443893-001

Before removing the display assembly, follow these steps:

1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the

computer on, and then shut it down through the operating system.

2. Disconnect all external devices connected to the computer.

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and

then unplugging the AC adapter from the computer.

4. Remove the battery (see

Battery on page 46).

5. Remove the memory/WLAN module compartment cover (see

Expansion memory module

on page 54).

6. Disconnect the wireless antenna cables from the WLAN module (see

WLAN module on page 56).

7. Remove the following components:

a. Keyboard (see

Keyboard on page 62)

b. Switch cover (see

Switch cover on page 68)

Remove the display assembly:

1. Disconnect the display panel cable (1) from the system board.

2. Remove the wireless antenna cables (2) from the routing channels and clips built into the top cover.

Component replacement procedures 75

Other manuals for HP COMPAQ 6510B

Questions and Answers:

Need help?

Do you have a question about the HP COMPAQ 6510B and is the answer not in the manual?

General